Loading ...
Loading ...
Loading ...
Side 2 starts from the endpoint of the section line.
7 Move the grip to the desired location, and click once; or enter a
value on the command line, and press ENTER.
8 Right-click, and click Deselect All to turn off grips.
To update a 2D or 3D section created from this section line, see Updating a
2D or 3D Section on page 3257.
Changing the Angle Dimensions of a Section
Use this procedure to change the angle of the sides of the building section
boundary. You can change the angle dimensions before or after you create a
connected section. If you change the angles after creating the section, you
need to update the section to show the changes.
1 Double-click the section line you want to change.
2 On the Properties palette, click the Design tab, expand Basic, and
expand Component Dimensions.
3 Specify values for Angle 1 and Angle 2.
These values define the angles of the two sides from the section
line to create the section box. The apex of Angle 1 is the start
point of the section line. The apex of Angle 2 is the endpoint of
the section line. Values for these angles must be between 0 and
90 degrees.
Specifying section angle parameters
4 Right-click, and click Deselect All to turn off grips.
3228 | Chapter 40 Sections
Loading ...
Loading ...
Loading ...