Loading ...
Loading ...
Loading ...
2 Click Mask Block Reference tab ➤ Modify panel ➤ Edit In Place
.
3 If prompted that the profile is not drawn to size, click Yes.
A temporary profile is created for you to edit the geometry of the
mask block.
4 NOTE After you perform an editing task from the Edit in Place tab,
you may need to select the profile again to perform another editing
task. If you do not see the editing commands that you expect on the
ribbon, reselect the profile, then choose the Edit in Place command
again.
Edit the profile:
Then…If you want to…
select the profile, and use edge or
vertex grips to adjust the shape.
change the shape of the perimeter
of the profile or its rings
The Edge grip has two edit modes:
Stretch and Move. The default
mode is Stretch, and the direction
of the stretch depends on the orient-
ation of edges connected to the
selected edge. For example, if the
edges at both ends of the selected
edge are parallel, the grip edit
mode is Stretch (Parallel) and the
stretch direction is limited to the
direction of the parallel edges. If the
connected edges are not parallel,
the grip edit mode is Stretch (Off-
set) and the stretch direction is
perpendicular to the direction of
the selected edge. The Move edit
mode allows an unconstrained
move of the selected edge.
Click Edit In Place tab ➤ Profile
panel ➤ Add Vertex . Select a
add vertices to the profile
point for each new vertex, and
press ENTER.
Editing the Profile of a Mask Block | 2849
Loading ...
Loading ...
Loading ...