Loading ...
Loading ...
Loading ...
11
Marking In and Out with precision
1 While still in the source tape viewer, drag the play head near the end of the first clip
where the chef picks up the pasta for the first time.
2 Press the I key on your keyboard to mark the start also called an in point.
3 Under the viewer, from the left side of the audio waveform display, drag the scratch trim
button to move slowly across the clip and precisely set the in point just before the chef
says “so this is spaghettini” .
This scratch trim button is used to reposition the in point on the clip with incredible
control and precision no matter the length of the clip in the viewer.
Dragging the scratch trim button moves the in point in consistently small increments no
matter if the clip is 5 seconds or 5 minutes long. This gives you much better control
over selecting the exact range you want to use in your program.
NOTE Scratch trim is very important when using the source tape, as you could
have lots of clips in your bin and loaded into the viewer. For even greater
precision in trimming in and out points, the DaVinci Resolve Editor Keyboard
has a large search dial that makes accurate trimming even faster.
Loading ...
Loading ...
Loading ...