Loading ...
Loading ...
Loading ...
Remote control commands
R&S
®
MXO 5 Series
692User Manual 1802.3369.02 ─ 02
Usage: Asynchronous command
17.16.4.2 Trigger
Trigger commands for serial buses affect the current trigger source. Therefore, set the
trigger source to the required serial bus with TRIGger:EVENt<ev>:SOURce before
sending the bus-specific trigger commands.
TRIGger:UART:DATA..................................................................................................... 692
TRIGger:UART:DPOSition...............................................................................................692
TRIGger:UART:FCONdition.............................................................................................692
TRIGger:UART:OPERator...............................................................................................693
TRIGger:UART:SOURce.................................................................................................693
TRIGger:UART:TYPE..................................................................................................... 693
TRIGger:UART:DATA <DataPattern>
Specifies the data pattern to be found on the specified trigger source. Enter the words
in MSB first bit order.
Parameters:
<DataPattern>
Usage: Asynchronous command
Manual operation: See "Value" on page 335
TRIGger:UART:DPOSition <DataPosition>
Sets the number of words before the first word of interest. These offset words are
ignored.
Parameters:
<DataPosition> Range: 1 to 4096
Increment: 1
*RST: 1
Usage: Asynchronous command
Manual operation: See "Position" on page 335
TRIGger:UART:FCONdition <DataOperator>
Selects the operator for the "Data" pattern.
Parameters:
<DataOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
*RST: EQUal
Usage: Asynchronous command
Manual operation: See "Data" on page 334
Protocols
Loading ...
Loading ...
Loading ...