Loading ...
Loading ...
Loading ...
Measurements
R&S
®
MXO 5 Series
211User Manual 1802.3369.02 ─ 02
Slope ← Delay measurement
Sets the edge of each source, between which the delay is measured: positive, nega-
tive, or either of them.
Remote command:
MEASurement<mg>:AMPTime:DELay<n>:SLOPe on page 562
Direction ← Delay measurement
Selects the direction for counting slopes for each source: from the beginning of the
waveform, or from the end.
Remote command:
MEASurement<mg>:AMPTime:DELay<n>:DIRection on page 561
Delay to trigger measurement settings
Delay to trigger measures the time between the trigger point and the following slope of
a waveform. The delay between the trigger and the slope can be high compared to the
accuracy of the acquisition, and the trigger point can even be outside of the current
acquisition.
Trigger
source
Measurement
source
Trigger
level
Reference
level
Slope
Trigger
event
Delay to trigger
To configure the trigger conditions, use the trigger setup.
"Edges slope"
Sets the edge direction to be used for delay measurement: positive,
negative, or either edge.
Remote command:
MEASurement<mg>:AMPTime:DTOTrigger<n>:SLOPe on page 562
9.2.6 Statistics
Access: "Menu" > "Measurement" > "Statistics" tab.
Automatic measurements
Loading ...
Loading ...
Loading ...