Loading ...
Loading ...
Loading ...
Waveform analysis
R&S
®
MXO 5 Series
182User Manual 1802.3369.02 ─ 02
In the "Rescale" tab you can adjust the vertical and horizontal scaling of the reference
waveform.
Vertical
Stretching and offset change the display of the waveform independent of the vertical
scale and position.
Enable ← Vertical
If enabled, the vertical offset and factor are applied to the reference waveform.
Remote command:
REFCurve<rc>:RESCale:VERTical:STATe on page 540
Scale factor ← Vertical
Sets the vertical scale factor. A factor greater than 1 stretches the waveform vertically,
a factor lower than 1 compresses the curve.
Remote command:
REFCurve<rc>:RESCale:VERTical:FACTor on page 539
Vertical offset ← Vertical
The vertical offset moves the reference waveform vertically. Enter a value with the unit
of the waveform.
Like vertical offset of a channel waveform, the offset of a reference waveform is sub-
tracted from the measured value. Negative values shift the waveform up, positive val-
ues shift it down.
Reference waveforms
Loading ...
Loading ...
Loading ...