Loading ...
Loading ...
Loading ...
Getting Started
R&S
®
MXO 5 Series
42User Manual 1802.3369.02 ─ 02
In particular, the horizontal scale is set to a common value for all active channels,
record length and sample rate are set to automatic detection. Vertical scale and offset
are set for each channel individually. Probe settings, channel coupling and impedance
remain unchanged. The trigger source is set to the signal with the lowest frequency,
and the trigger type to positive edge. The trigger level is adjusted, and the trigger posi-
tion is set to the reference point. Measurements, math and spectrum waveforms are
kept. Undo and redo of an autoset is possible.
[Clear]
Deletes all measurement results including long-term measurement and statistics, all
waveforms, and the history.
Apps
Opens the "Apps" dialog, where you can start an application, serial protocol or another
analysis function.
3.2.5 Checking the functionality
To check if the instrument works correctly, you can use the probe compensation signal
and check the displayed signal.
1. Perform a self-alignment of the instrument:
a) Warm up the instrument. The minimum warm-up time is indicated in the data
sheet.
b) Remove all probes from the input connectors.
c) Open the "Menu", and select "Settings" > "Maintenance" > "Alignment".
d) Tap "Start Alignment". Wait until the alignment has finished successfully.
2.
Connect the probe's ground connector to the ground pin
, and the tip to the
square wave pin .
3. Press the [Preset] key.
4. Connect the probe to the input connector [C1].
The instrument recognizes the probe, and a signal is displayed in the diagram.
5. Tap the signal icon of C1 to open the vertical settings.
6. In the "Vertical" > "Setup" dialog, adjust the following:
● "Vertical scale" = 600 mV/div
● "Offset" = 900 mV
Instrument tour
Loading ...
Loading ...
Loading ...