Loading ...
Loading ...
Loading ...
Remote control commands
R&S
®
MXO 5 Series
428User Manual 1802.3369.02 ─ 02
17 Remote control commands
This chapter describes all remote commands available for R&S MXO 5 and provides
examples and information how to use the commands.
For general information on remote control of Rohde & Schwarz products via SCPI,
refer to www.rohde-schwarz.com/rc-via-scpi.
See also Chapter 16.4, "Remote control", on page 415 and Chapter 16.5, "Remote
control - status reporting system", on page 418 for further information on remote con-
trol.
The description of the remote commands, assume a R&S MXO 5 with the highest
available bandwidth and number of channels. Depending on your model, some of the
available command ranges can differ from the values stated in the following chapters.
17.1 Conventions used in remote command description
The basics of SCPI command structure, syntax and command parameters are
explained in www.rohde-schwarz.com/rc-via-scpi.
The following conventions are used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as Setting parameters.
Parameters required only to refine a query are indicated as Query parameters.
Parameters that are only returned as the result of a query are indicated as Return
values.
●
Conformity
Commands that are taken from the SCPI standard are indicated as SCPI con-
firmed. All commands used by the R&S MXO 5 follow the SCPI syntax rules.
●
Asynchronous commands
A command which does not automatically finish executing before the next com-
mand starts executing (overlapping command) is indicated as an Asynchronous
command.
●
Reset values (*RST)
Default parameter values that are used directly after resetting the instrument (*RST
command) are indicated as *RST values, if available.
●
Default unit
Conventions used in remote command description
Loading ...
Loading ...
Loading ...