Loading ...
Loading ...
Loading ...
Remote control commands
R&S
®
MXO 5 Series
688User Manual 1802.3369.02 ─ 02
MARK
The parity bit is always a logic 1.
SPC
SPaCe: The parity bit is always a logic 0.
DC
Do not care: the parity is ignored.
*RST: NONE
Usage: Asynchronous command
Manual operation: See "Parity" on page 329
SBUS<sb>:UART:POLarity
<Polarity>
Defines the logic levels of the bus. The idle state corresponds to a logic 1. The start bit
corresponds to a logic 0. "Idle high" (high=1) is used, for example, for control signals,
while "Idle low" (low=1) is defined for data lines (RS-232).
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Polarity> IDLLow | IDLHigh
*RST: IDLHigh
Usage: Asynchronous command
Manual operation: See "Polarity" on page 329
SBUS<sb>:UART:RX:HYSTeresis <Rx hysteresis>
Sets the hysteresis for the Tx line.
Suffix:
<sb>
.
1...4, index of the serial bus
Parameters:
<Rx hysteresis>
Usage: Asynchronous command
Manual operation: See "Threshold" on page 330
SBUS<sb>:UART:RX:SOURce RXSource
Selects the input channel for the receiver signal.
Suffix:
<sb>
.
1...4, index of the serial bus
Protocols
Loading ...
Loading ...
Loading ...