Loading ...
Loading ...
Loading ...
Acquisition and waveform setup
R&S
®
MXO 5 Series
120User Manual 1802.3369.02 ─ 02
Most the settings in the "Probe" tab are available for all probes. For some probe types,
additional settings are needed. These settings are described in the sections for the
individual probe types.
An external attenuation can be set on the "Other" tab, see Chapter 6.3.5, "Other verti-
cal settings", on page 118.
The common probe settings are:
Predefined probe, name and type of the probe...........................................................120
Probe bandwidth......................................................................................................... 121
Offset...........................................................................................................................121
Vertical unit..................................................................................................................121
Manual attenuation......................................................................................................121
Set offset to mean....................................................................................................... 121
AutoZero, Use AutoZero............................................................................................. 122
Predefined probe, name and type of the probe
The model name and type of a detected probe are shown in the dialog.
If the instrument cannot recognize the probe, "None" is indicated in the "Predefined
probe" list. Select the used probe on the list. The corresponding bandwidth, and
attenuation or gain are shown.
If the probe is not detected and not listed as predefined probe, it is an unknown probe.
To configure these probes, set "Predefined probe" to "User-Defined". Then adjust the
Vertical unit and Manual attenuation.
Probes
Loading ...
Loading ...
Loading ...