Loading ...
Loading ...
Loading ...
Getting Started
R&S
®
MXO 5 Series
35User Manual 1802.3369.02 ─ 02
Ref Out 10 MHz
BNC output for 10 MHz frequency reference. Can be switched between internal and
external reference.
See also: "Menu" > "Horizontal" > "Setup" tab > "Ref Clock"
Gen1, Gen2: Function generator
BNC output of the function generator, requires option R&S MXO5-B6.
Trigger In
The external trigger input is a BNC connector that is used to control the measurement
by an external signal. The trigger level can be set from -5 V to 5 V.
For the external trigger input, the maximum input voltage is 400 V (V
p
) and
300 V (RMS) at 1 MΩ input impedance.
Transient overvoltages on all input connectors must not exceed 400 V (V
p
).
AC power supply connector and main power switch
The instrument supports a wide range power supply. It automatically adjusts to the cor-
rect range for the applied voltage. There is no line voltage selector.
The AC main power switch disconnects the instrument from the AC power line.
When you power up the instrument, be sure to comply with the warm-up phase speci-
fied in the data sheet before you start measurements.
3.2.4 Keys and controls
For an overview of the front panel keys, see Chapter 3.2.1, "Front view", on page 30.
3.2.4.1 Power key
The [Power] key is located on the lower left corner of the front panel. It starts up and
shuts down the instrument's software.
The light of the key shows the instrument state, see Chapter 3.1.9, "Switching on or
off", on page 29.
Remote command: SYSTem:SHUTdown on page 442.
3.2.4.2 Trigger controls
The keys and knob in the Trigger functional block adjust the trigger and start or stop
acquisition.
Instrument tour
Loading ...
Loading ...
Loading ...