Loading ...
Loading ...
Loading ...
Protocol analysis
R&S
®
MXO 5 Series
342User Manual 1802.3369.02 ─ 02
Type
Selects the CAN-High or CAN-Low line. CAN uses both lines for differential signal
transmission.
If you measure with a differential probe, connect the probe to both CAN-H and CAN-L
lines, and select the data "Type" = CAN-H.
If you use a single-ended probe, connect the probe to either CAN_L or CAN_H, and
select the data type accordingly.
Remote command:
SBUS<sb>:CAN:TYPE on page 701
Transceiver mode
Selects the transceiver mode for the CAN decoding.
"SIC mode"
Signal improvement capability (SIC) mode. The possible bit rate is up
to 8 Mbit.
"FAST mode"
Fast mode. The possible bit rate is up to 20 Mbit.
Remote command:
SBUS<sb>:CAN:TRCVmode on page 704
Nominal bit rate
Sets the number of transmitted bits per second.
Remote command:
SBUS<sb>:CAN:BITRate on page 701
Sample point
Sets the position of the sample point within the bit in percent of the nominal bit time.
Remote command:
SBUS<sb>:CAN:SAMPlepoint on page 702
FD bit rate
Sets the number of transmitted bits per second for the CAN FD frame.
Remote command:
SBUS<sb>:CAN:FDATa:DBITrate on page 702
FD sample point
Sets the position of the sample point within the bit in percent of the nominal bit time for
the CAN FD frame.
Remote command:
SBUS<sb>:CAN:FDATa:SAMPlepoint on page 702
XL bit rate
Sets the number of transmitted bits per second for the CAN XL frame.
Remote command:
SBUS<sb>:CAN:XDATa:DBITrate on page 704
CAN (option R&S
MXO5-K520)
Loading ...
Loading ...
Loading ...