Loading ...
Loading ...
Loading ...
Remote control commands
R&S
®
MXO 5 Series
510User Manual 1802.3369.02 ─ 02
Suffix:
<ev>
.
1, can be omitted
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
Manual operation: See "Slope" on page 151
17.9.10 Trigger mode, holdoff
TRIGger:MODE............................................................................................................. 510
TRIGger:FORCe............................................................................................................510
TRIGger:HOLDoff:MODE................................................................................................511
TRIGger:HOLDoff:AUTotime?..........................................................................................511
TRIGger:HOLDoff:SCALing.............................................................................................512
TRIGger:HOLDoff:EVENts.............................................................................................. 512
TRIGger:HOLDoff:MAX.................................................................................................. 512
TRIGger:HOLDoff:MIN....................................................................................................513
TRIGger:HOLDoff:TIME..................................................................................................513
TRIGger:MODE <TriggerMode>
Sets the trigger mode which determines the behavior of the instrument with and with-
out a trigger event.
Parameters:
<TriggerMode> AUTO | NORMal | FREerun
AUTO
The instrument triggers repeatedly after a time interval if the trig-
ger conditions are not fulfilled. If a real trigger occurs, it takes
precedence. The time interval depends on the time base.
NORMal
The instrument acquires a waveform only if a trigger occurs.
FREerun
The instrument triggers after a very short time interval - faster
than in AUTO mode. Real triggers are ignored.
*RST: AUTO
Usage: Asynchronous command
Manual operation: See "Trigger mode" on page 153
TRIGger:FORCe
Provokes an immediate single acquisition. Force the trigger if the acquisition is running
in normal mode and no valid trigger occurs. Thus, you can confirm that a signal is
available and use the waveform display to determine how to trigger on it.
Trigger
Loading ...
Loading ...
Loading ...