Loading ...
Loading ...
Loading ...
Getting Started
R&S
®
MXO 5 Series
27User Manual 1802.3369.02 ─ 02
3.1.5 Considerations for test setup
Observe safety instructions, see "Performing measurements" on page 17.
Cable selection and electromagnetic interference (EMI)
Electromagnetic interference (EMI) can affect the measurement results.
To suppress electromagnetic radiation during operation:
●
Use high-quality shielded cables, for example, double-shielded RF and LAN
cables.
●
Always terminate open cable ends.
●
Ensure that connected external devices comply with EMC regulations.
Measuring accessories
Use only probes and measuring accessories that comply with IEC 61010-031.
Signal input and output levels
Information on signal levels is provided in the data sheet. Keep the signal levels within
the specified ranges to avoid damage to the product and connected devices.
During operation, if the firmware observes a serious unexpected disturbance (e.g. due
to ESD), it resets some hardware components and initiates a new alignment to ensure
proper instrument functioning. Then it restores the user settings to the state before the
disturbance.
3.1.6 Connecting to power
For safety information, see "Connecting to power and grounding" on page 17.
The R&S MXO 5 can be used with different AC power voltages and adapts itself auto-
matically to it.
The nominal ranges are indicated on a label near the power connector on the instru-
ment and in the data sheet.
1. Plug the AC power cable into the AC power connector on the rear panel of the
product. Only use the AC power cable that is delivered with the product.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
If the voltage dips at the AC power connector (according to EN 61326-2-1 6.4.101), a
restart of the R&S MXO 5 can happen. All instrument settings are restored after the
restart.
Preparing for use
Loading ...
Loading ...
Loading ...