Loading ...
Loading ...
Loading ...
Trigger
R&S
®
MXO 5 Series
140User Manual 1802.3369.02 ─ 02
"DC 1 MΩ"
Connection with 1 MΩ termination, passes both DC and AC compo-
nents of the signal.
"AC 1 MΩ"
Connection with 1 MΩ termination through DC capacitor, removes DC
and very low-frequency components. The waveform is centered on
zero volts.
Remote command:
TRIGger:ANEDge:COUPling on page 495
Filter, Cut-off
Selects the filter mode for the external trigger signal, and sets the cut-off frequency.
"Off"
The trigger signal is not filtered.
"LF reject"
Frequencies lower than the "Cut-off" frequency are rejected, higher
frequencies pass the filter.
"RF reject"
Frequencies higher than the "Cut-off" frequency are rejected, lower
frequencies pass the filter.
Remote command:
TRIGger:ANEDge:FILTer on page 495
TRIGger:ANEDge:CUToff:HIGHpass on page 496
TRIGger:ANEDge:CUToff:LOWPass on page 496
Trigger noise reject
Enables an automatic hysteresis on the trigger level to avoid unwanted trigger events
caused by noise.
Remote command:
TRIGger:ANEDge:NREJect on page 496
7.3.3 Glitch trigger
Access: "Menu" > "Trigger" > "Setup" tab > "Type = Glitch"
Trigger types
Loading ...
Loading ...
Loading ...