Loading ...
Loading ...
Loading ...
Protocol analysis
R&S
®
MXO 5 Series
338User Manual 1802.3369.02 ─ 02
15. Set the logical thresholds:
a) Tap "Threshold setup". The threshold dialog opens.
b) For each line, set the threshold value. A typical value is 2.5 V.
c) If necessary, set the hysteresis value for the wires.
d) Optionally, tap on "Show threshold lines".
13.4.6.2 Triggering on UART
Prerequisites: A bus is configured for the UART signal to be analyzed. See Configuring
UART signals.
1. Open "Menu" > "Trigger".
2. Set "Trigger on" to "Single event".
3. Ensure that the "Source" is set to the configured serial bus, e.g. "Serial bus 1".
4. Select the "Type": "Start bit", "Packet start", "Parity error", "Break condition" and
"Stop error".
UART (option R&S
MXO5-K510)
Loading ...
Loading ...
Loading ...