Loading ...
Loading ...
Loading ...
Measurements
R&S
®
MXO 5 Series
189User Manual 1802.3369.02 ─ 02
Remote command:
CURSor<cu>:USSource on page 580
CURSor<cu>:SSOurce on page 580
Source
Defines the source of the cursor measurement. Any of the input signal, math or refer-
ence waveforms can be selected.
Remote command:
CURSor<cu>:SOURce on page 579
Envelope, Envelope 2
Define which horizontal cursor is positioned to the maximum and which to the minimum
envelope values.
Envelope selection is effective under the following conditions:
●
The acquisition mode of the cursor source waveform is set to envelope, see Acqui-
sition mode.
●
Track waveform is enabled.
●
Both horizontal and vertical cursors are enabled (Type = "X&Y").
"Minimum"
The horizontal cursor is set to the crossing point of the vertical cursor
with the minimum waveform envelope.
"Maximum"
The horizontal cursor is set to the crossing point of the vertical cursor
with the maximum waveform envelope.
Remote command:
CURSor<cu>:X1ENvelope on page 583
CURSor<cu>:X2ENvelope on page 583
X1 position, X2 position
Define the left and right position of the vertical cursors.
Remote command:
CURSor<cu>:X1Position on page 580
CURSor<cu>:X2Position on page 581
Y1 position, Y2 position
Define the upper and lower position of the horizontal cursor lines.
If Track waveform is enabled, the user setting is disabled and the measurement results
are displayed in the result table.
Remote command:
CURSor<cu>:Y1Position on page 581
CURSor<cu>:Y2Position on page 581
Track waveform
The horizontal cursors track the waveform. The first cursor line indicates the current
vertical minimum, and the second cursor line indicates the maximum. If the waveform
changes, e.g. during a running measurement, the cursors move along with it.
If both horizontal and vertical cursors are displayed, the horizontal cursors are posi-
tioned to the crossing points of the vertical cursors with the waveform. The measure-
ment results are displayed in the cursor result box.
Cursor measurements
Loading ...
Loading ...
Loading ...