Loading ...
Loading ...
Loading ...
Applications
R&S
®
MXO 5 Series
236User Manual 1802.3369.02 ─ 02
Remote command:
FRANalysis:FREQuency:STARt on page 604
FRANalysis:FREQuency:STOP on page 605
Points
Selects, if the number of points are measured as total or per decade and sets the num-
ber of points.
Remote command:
FRANalysis:POINts:TOTal on page 608
FRANalysis:POINts:MODE on page 607
FRANalysis:POINts:LOGarithmic on page 607
Amplitude
Sets a fixed amplitude for the frequency response analysis.
Remote command:
FRANalysis:GENerator:AMPLitude on page 605
User load
Selects the generator voltage display for 50Ω or high impedance load.
Remote command:
FRANalysis:GENerator:LOAD on page 605
Amplitude mode
Selects, if the amplitude is a constant value ("Amplitude") or is defined as an amplitude
profile.
Remote command:
FRANalysis:POINts:MODE on page 607
Amplitude profile
Opens a dialog to set the amplitude profile. See Chapter 11.1.3.2, "Amplitude profile",
on page 237.
You can then define different amplitudes for different frequencies. The amplitude profile
is useful when testing sensitive circuits, where the amplitude gets too high. In this case
distortion might occur.
If this function is enabled, a green colored diagram of the amplitudes for the different
frequencies can be displayed on the screen.
Remote command:
FRANalysis:AMPLitude:MODE on page 604
FRANalysis:AMPLitude:ENABle on page 613
Run
Starts the frequency response analysis.
Remote command:
FRANalysis:STATe on page 603
Repeat
Repeats the measurement, using the same parameters.
Frequency response analysis (option R&S
MXO5-K36)
Loading ...
Loading ...
Loading ...