Loading ...
Loading ...
Loading ...
Acquisition and waveform setup
R&S
®
MXO 5 Series
104User Manual 1802.3369.02 ─ 02
The "Roll" progress bar in the "Acquisition" label shows how the record length is filled,
see "Progress bar" on page 102. If "Off screen capture" = Off, the analyzable record
length is the value that is set in the "Acquisition" > "Setup" tab. If "Off screen capture" =
On, the analyzable record length is longer. The value is shown in the progress bar
when the bar is green, or returned by the remote command ACQuire:ROLLmode:
POINts?.
Remote command:
ACQuire:ROLLmode:OSCapture on page 463
ACQuire:ROLLmode:POINts? on page 464
6.1.5 Reference clock
Access: "Menu" > "Horizontal" > "Setup" tab > "Ref Clock"
The oven-controlled crystal oscillator (OCXO) produces a 10 MHz internal reference
signal with precise and stable frequency. You can output this clock signal for synchroni-
zation of other instruments. Conversely, you can also use an external 10 MHz refer-
ence signal. The input and output connectors for reference signals are on the rear
panel of the instrument.
Use external ref. clock
Enables the use of an external 10 MHz reference signal instead of the internal refer-
ence clock.
Remote command:
SENSe[:ROSCillator]:SOURce on page 492
Output 10 MHz ref. signal
Sends the internal reference clock signal to the Ref Out 10 MHz connector.
If "Use external ref. clock" is enabled, the external reference signal is output instead of
the internal clock.
Remote command:
SENSe[:ROSCillator]:OUTPut[:ENABle] on page 491
6.2 Acquisition
Access: "Menu" > "Acquisition".
Acquisition settings define the processing of the captured samples in the instrument.
Acquisition
Loading ...
Loading ...
Loading ...