Loading ...
Loading ...
Loading ...
Getting Started
R&S
®
MXO 5 Series
26User Manual 1802.3369.02 ─ 02
3.1.4.2 Mounting the product on a monitor arm
You can mount the oscilloscope to a monitor arm with VESA mount.
1.
NOTICE! Only use a VESA mount compatible to FDMI MIS-D, up to 14kg with
M4x10 screws and standard 100 mm × 100 mm pattern.
Order the VESA adapter R&S MXO5-Z7. For the order number, see data sheet.
2. Mount the adapter to the rear panel of the oscilloscope. Follow the assembly
instructions provided with the adapter.
3. Mount the VESA mount of the monitor arm to the VESA adapter.
3.1.4.3 Mounting the product in a rack
The instrument can be installed in a rack using a rack adapter kit. The order number is
given in the data sheet. The installation instructions are part of the adapter kit.
To prepare the rack
1. Observe the requirements and instructions in "Setting up the product" on page 16.
2.
NOTICE! Insufficient airflow can cause overheating and damage the product.
Design and implement an efficient ventilation concept for the rack.
To mount the oscilloscope in a rack
1. Use an adapter kit to prepare the product for rack mounting.
a) Order the rack adapter kit designed for the R&S MXO 5 series oscilloscope.
For the order number, see data sheet.
b) Mount the adapter kit. Follow the assembly instructions provided with the
adapter kit.
2. Lift the product to shelf height. If the rack is high, use a safe climbing aid when
placing on upper shelves.
3. Grip the product by the handles. Slide the product onto the shelf until the rack
brackets fit closely to the rack.
4. Tighten all screws at the rack brackets with a tightening torque of 1.2 Nm to secure
the product at the rack.
To unmount the product from a rack
1. Loosen the screws at the rack brackets.
2. Remove the product from the rack.
3. If placing the product on a bench top again, unmount the adapter kit from the prod-
uct. Follow the instructions provided with the adapter kit.
Preparing for use
Loading ...
Loading ...
Loading ...