Loading ...
Loading ...
Loading ...
Protocol analysis
R&S
®
MXO 5 Series
319User Manual 1802.3369.02 ─ 02
No Ack conditions
Selects which missing acknowledge bits is detected if the trigger type is set to "No
Ack".
"Address Nack"
No secondary recognizes the address.
"Data write Nack"
The addressed secondary does not accept the data.
"Data read Nack"
Marks the end of the read process when the primary reads data from
the secondary. This Nack is sent according to the protocol definition,
it is not an error.
Remote command:
TRIGger:I2C:ADNack on page 671
TRIGger:I2C:DWNack on page 673
TRIGger:I2C:DRNack on page 672
Address type
Sets the address length to be triggered on: 7 bit or 10 bit.
Remote command:
TRIGger:I2C:AMODe on page 672
R/W bit
Toggles the trigger condition between read and write access of the primary. Select
"Either" if the transfer direction is not relevant for the trigger condition.
Remote command:
TRIGger:I2C:ACCess on page 670
Address
The trigger address setup consists of a comparison condition and one or two address
patterns.
Defines the bit pattern of the secondary device address. The length of the entry is
adjusted to the selected address type.
"Condition"
Sets the comparison condition to a specific value or a range.
I²C (option R&S MXO5-K510)
Loading ...
Loading ...
Loading ...