Loading ...
Loading ...
Loading ...
Protocol analysis
R&S
®
MXO 5 Series
287User Manual 1802.3369.02 ─ 02
Threshold
Press "Set thresholds", to open the "Threshold setup" dialog.
In the "Threshold setup" dialog, you can set values for threshold and hysteresis.
Show threshold lines ← Threshold
In the "Threshold" dialog, you can enable the display of the threshold lines in the dia-
gram.
The label of the threshold line is set according to the signal that it is referring to. It is
displayed in the color of the signal channel.
Example:
When the "Show threshold lines" is enabled, the threshold lines and the hysteresis are
shown on the display for a few seconds. Afterwards only the threshold line is visible.
Figure 13-1: Threshold lines, shortly after Show threshold lines is enabled
Remote command:
SBUS<m>:THReshold on page 646
Basics of protocol analysis
Loading ...
Loading ...
Loading ...