Loading ...
Loading ...
Loading ...
Shimming mounts
To shim your camera’s mounts you’ll need a torque wrench able to accurately set a maximum
torque of 0.45Nm, with a 2.0mm Hex key and driver.
Torque wrench
1 2
Place URSA Broadcast G2 vertically on a solid,
clean bench top and remove your lens or dust cap.
Thefilter covering the sensor will be exposed for the
duration of the shimming process, so it’s important
to keep the filter as clean as possible. Be careful not
to touch the filter while shimming mounts.
Remove the screws holding your mount in place
using a 2.0mm Hex driver. For more information
on removing particular mounts, see the
‘interchangeable lens mount’ section in this manual.
3 4
Carefully lift the lens mount away from the camera
body. Keep the screws safely located close to the
lens mount.
Note the alignment of the existing shim with the
alignment pin at the 11 o’clock position.
201Shimming Lens Mounts
Loading ...
Loading ...
Loading ...