Loading ...
Loading ...
Loading ...
Using your own Battery Plate
Adapter Cable and Connector
If you want to modify a third party battery plate for use with your URSA Broadcast G2, you
can use the supplied adapter cable and connector, which is also available at your local
Blackmagic Design support office.
To wire the adapter cable and connector to your battery plate:
1 Strip approximately half an inch of insulation from the end of each red and black wire.
2 Solder all 4 x red ‘Batt’ wires to the corresponding ‘positive’ wire from your
battery plate.
3 Solder all 4 x black ‘GND’ wires to the corresponding ‘negative’ wire from your
battery plate.
Ensure the joins are well insulated.
If you need to modify any battery plate to plug into URSA Broadcast G2,
use the supplied adapter cable and connector, which is also available
from your local Blackmagic Design support office
This enables battery power to your camera. You can also connect additional wires for features
such as 12 V output and battery status. Refer to your battery plate information, plus the diagram
and tables on this page for help connecting the wires. If you require further assistance visit the
Blackmagic Design support center at www.blackmagicdesign.com/support.
The rear view of the adapter’s connector housing. Refer to
thewireconfiguration table for a description of each pin
152Mounting Batteries
Loading ...
Loading ...
Loading ...