Loading ...
Loading ...
Loading ...
NOTE Before installing Blackmagic Camera Fiber Converter you should check that
URSA Mini’s internal software is version 4.4 or above and URSA Broadcast G2 is 4.6 or
above. You can check your software version on page 4 of the camera’s ‘setup’ menu.
For more information on updating your camera firmware see the section ‘Blackmagic
Camera Setup Utility’ in this manual.
When attaching Blackmagic Camera Fiber Converter, you will need the following tools:
1 x phillips head screwdriver
1 x 2.5mm Hex driver
To attach the Blackmagic Camera Fiber Converter to your URSA Broadcast G2 or
URSAMini, you will need a large phillips head screwdriver and a 2.5mm Hex driver
To mount and connect Blackmagic Camera Fiber Converter:
1 2
Ensure your camera is powered off. If using URSA
Broadcast G2 or URSA Mini Pro, power it off by
moving the power switch to ‘off’.
Remove the battery plate or molex power cover
plate, if attached, using a phillips head screwdriver.
3 4
Attach Blackmagic Camera Fiber Converter’s
mounting bracket using 6 x 2.5mm Hex screws.
Plug the molex connector on Blackmagic Camera
Fiber Converter into the molex power socket on
your camera’s rear panel.
163Getting Started with BlackmagicFiberConverters
Loading ...
Loading ...
Loading ...