Loading ...
Loading ...
Loading ...
Effect parameters |1323
f Horn/Rotor
Balance
Rotor, 1…99, Horn Sets the volume balance between the high-range
horn and low-range rotor
Manual SpeedCtrl Of f…Tempo Sets a modulation source for direct control of
rotation speed
g Horn
Acceleration
0…100 Sets how quickly the horn rotation speed chang-
es
Horn Ratio Stop, 0.50…2.00 Adjusts the (high-frequency) horn rotation
speed. Standard value is 1.00. “Stop” stops the
rotation
h Rotor
Acceleration
0…100 Sets how quickly the rotor speed changes
Rotor Ratio Stop, 0.50…2.00 Adjusts the (low-frequency) rotor rotation speed.
Standard value is 1.0. “Stop” stops the rotation
i Mic Distance 0…100 Distance between the microphone and rotary
speaker
Mic Spread 0…100 Angle of left and right microphones
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation
Sources) at the beginning of this part
Amt –100…+100 Amount of modulation source
▪ a: Sw
This parameter determines how to switch on/off the overdrive via a modulation
source.
When “Sw” = Toggle, overdrive is turned on/off each time the pedal or joystick is
operated.
Overdrive will be switched on/off each time the value of the modulation
source exceeds 64.
When “Sw” = Moment, overdrive is applied only when you press the pedal or oper-
ate the joystick.
Only when the value for the modulation source is 64 or higher, the over-
drive effect is applied.
Loading ...
Loading ...
Loading ...