Loading ...
Loading ...
Loading ...
1144| Effects for the Sounds
▪ “Hold” procedure (when Loop Time = Auto)
1 Select the following options for each parameter:
Parameter Option
Loop Time [msec] Auto
REC Control Src JS +Y: #01
RST Control Src JS –Y: #02
Manual REC ControlJS –Y: #02 REC Off
Manual RST Control RESET
Loop BPM Sync Off
It should be noted that all recordings will be deleted while Reset is On.
2 Set “Manual RST Control” = Off
Reset is cancelled and the unit enters Rec ready mode.
3 Push the joystick in the +Y direction (forward) and play a phrase you wish
to hold. When you pull the joystick to its original position, the recording will be
nished and the phrase you just played will be held.
Loop Time is automatically set only for the rst recording after resetting. If
the time length exceeds 10,800msec, Loop Time will be automatically set to
10,800msec. (If you have set “Times” to 1–10,800msec, the specied loop time
will be used regardless of the time taken from pushing the joystick forward until
it is pulled back. However, the recording method remains the same. The phrase
being played while the joystick is pushed forward will be held.)
4 If you made a mistake during recording, pull the joystick in the –Y direc-
tion (back) to reset. In this way, the recording will be erased. Repeat step 4. again.
5 The recorded phrase will be repeated again and again. You can use this
to create an accompaniment.
6 By pushing the joystick in the +Y direction (forward), you can also over-
dub performances over the phrase that is being held.
▪ e: REC Control Src
▪ g: Manual REC Control
“REC Control Src” selects the modulation source that controls recording.
If this modulation is on, or if “Manual REC Control” is set to On, you can record
the input signal. If a recording has already been carried out, additional signals will
be overdubbed.
Loading ...
Loading ...
Loading ...