Loading ...
Loading ...
Loading ...
1120| Effects for the Sounds
h High Damp [%] 0…100 Sets the damping amount in the high range
Low Damp [%] 0…100 Sets the damping amount in the low range
i Saturation 0…100 Sets the distortion amount
j Input Trim 0…100 Sets the input gain
Pre Tone 0…100 Sets the tone of the input
k Wow Flutter [Hz] 0.02…1.00 Sets the frequency at which pitch variation will occur
Wow Flutter depth 0…100 Sets the depth of pitch variation
l Wet/Dry Dry,
1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation Sources) at
the beginning of this part
Amt –100…+100 Amount of modulation source
▪ a: Delay (Tap1) [msec]
▪ a: Src
▪ a: Amt
▪ b: Tap2 Position [%]
▪ b: Tap3 Position [%]
The delay time for Tap 2 and 3 is specied as a proportion (%) relative to “Delay
(Tap1).” Even if you use dynamic modulation to control “Delay (Tap1),” Tap 2 and 3
will change at the same proportion.
▪ d: FB Amt
▪ e: FB Amt
▪ f: FB Amt
▪ g: Feedback
The feedback output from Tap 1, 2, and 3 is mixed according to the “FB Amt,” and
then the nal amount of feedback is specied by “Feedback.”
Loading ...
Loading ...
Loading ...