Loading ...
Loading ...
Loading ...
1196| Effects for the Sounds
g Noise Level 0...100 Sets the noise mix level to the Carrier
Src Off...Tempo Selects the modulation source for the noise mix level
Amt –100...+100 Sets the modulation amount for the noise mix level
h Modulator
High Mix
0...100 Sets the high-range output level of the modulator
i Low Gain [dB] –12...+12 Sets the low-range output level of the vocoder
High Gain [dB] –12...+12 Sets the high-range output level of the vocoder
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation Sources) at
the beginning of this part
Amt –100…+100 Amount of modulation source
▪ e: Formant Shift
By offsetting the Carrier lter, you can adjust the height of the frequency range
to which the vocoder effect is applied. The tonal quality will change signicantly.
▪ g: Noise Level
This parameter enables you to mix white noise with the Carrier.
▪ h: Modulator High Mix
This parameter sets the high-range output level of the modulator sound. If the
modulator is a human voice, it will make the words more clear.
▪ Using the vocoder with the microphone input
When programming the Vocoder, you can start from one of the specially pro-
grammed Vocoder Keyboard Sets (in the Synth group) as templates.
To use a voice from a microphone as a modulator:
1 Turn the microphone channel off (you can use BUTTON #1 while in the MAIN
mode of the
CONTROL section).
2 Connect a microphone to the MIC audio input.
3 Set Modulator Source to FX Control 1.
4 Speak into the microphone while you use the GAIN knob (next to the MIC
input) to adjust the level as high as possible without allowing distortion to occur.
Loading ...
Loading ...
Loading ...