Loading ...
Loading ...
Loading ...
Effect parameters |1113
f MIDI Sync Off, On When this is on, the LFO speed is set by BPM, Base
Note, and Times, instead of Frequency
BPM MIDI,
40.00…
300.00
MIDI syncs to the system tempo; 40–300 sets the
tempo manually for this individual effect
Base Note
…
Selects the type of notes that specify the LFO speed
Times x1…x32 Sets the number of notes that specify the LFO speed
g L LFO Phase [deg] –180…+180 Sets the phase obtained when the left LFO is reset
L Depth 0…200 Sets the depth of the left LFO modulation
h R LFO Phase [deg] –180…+180 Sets the phase obtained when the right LFO is reset
R Depth 0…200 Sets the depth of the right LFO modulation
i L Delay Time [msec] 0.0…1000.0 Sets the delay time for the left channel
L Feedback –100…+100 Sets the feedback amount of left delay
j R Delay Time [msec] 0.0…1000.0 Sets the delay time for the right channel
R Feedback –100…+100 Sets the feedback amount of right delay
k Wet/Dry -Wet, -1:99…
Dry…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation Sources) at
the beginning of this part
Amt –100…+100 Amount of modulation source
▪ b: D-mod Modulation
When the modulation source is used for control, this parameter reverses the left
and right modulation direction.
▪ d: LFO Sync
▪ d: Src
▪ g: L LFO Phase [deg]
▪ h: R LFO Phase [deg]
If “LFO Sync” is On, the LFO will be reset by the modulation source that is received.
The “Src” parameter sets the modulation source that resets the LFO. For example,
you can assign Gate as a modulation source so that the sweep always starts from
the specied point.
Loading ...
Loading ...
Loading ...