Loading ...
Loading ...
Loading ...
Effect parameters |1195
Vocoder
This effect applies the timbral character of a different signal (the modulator) to
the input signal (the carrier).
A common use of this effect is to produce the sound of various instruments by in-
putting a voice to the Modulator via a microphone. A special effect is also achieved
by using rhythm or effect sounds. Strings or distortion guitar sounds with a lot of
harmonics are suitable as Carrier signals.
When this effect is selected, the microphone input no longer goes to the Voice
Processor, but is routed to this FX processor.
Left
Right
FX Amt
FX Amt
FX Amt = 100: Stereo In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
Band Pass Filter
Envelope
Carrier Trim
Modulator Trim
Modulator High Mix
Noise
Generator
Noise Level
+
+
FX Control BUS 1
FX Control BUS 2
Modulator Source
Modulator Select
+
+
a Carrier Trim 0...100 Sets the carrier input level
b Modulator
Trim
0...100 Sets the modulator input level
c Modulator
Source
Input, FX Control
1, FX Control 2
Choose either FX Control 1 or 2 to select the micro-
phone input as the modulator.
Choose FX Control 1 for the Left Line input, or FX
Control 2 for the Right Line input.
Choose Input to use the Sound as the modulator. If you
want to use the keyboard as the modulator, apply the
Vocoder effect to one of the Upper Sounds.
d Modulator
Select
L/R Mix, L Only,
R Only
Selects whether to use the left/right mix, only left, or
only right of the modulator input
e Formant Shift –2...+2 Sets the height of the frequency for the vocoder effect
f Response 0...100 Sets the speed of the response to the modulator input
Loading ...
Loading ...
Loading ...