Loading ...
Loading ...
Loading ...
Effect parameters |1143
i Pan L100…L1, C, R1…
R100
Sets the stereo image of the effect
Src Off…Tempo Selects the modulation source of stereo image of
the effect
Amt –100…+100 Sets the modulation amount of stereo image of
the effect
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation Sources)
at the beginning of this part
Amt –100…+100 Amount of modulation source
▪ a: Loop Time [msec]
With Auto, the loop time is automatically set. Otherwise, you can specify the loop
time.
When Auto is selected, the Loop Time is automatically set to the time it takes for
a performance recorded while the Modulation Source or “Manual REC Control” is
on. However, if the time length exceeds 10,800msec, the loop time will be auto-
matically set to 10,800msec.
▪ c: Time Over?
You can set the delay time up to 10,800msec. If the delay time exceeds this limit,
the error message “OVER!” appears in the display. Set the delay time parameters
so that this message will not appear. “Time Over?” is only a display parameter.
▪ b: Loop BPM Sync
▪ c: BPM
▪ d: Loop Base Note
▪ d: Times
If “Loop BPM Sync” is on, the “Times” setting is ignored; the loop time is deter-
mined by “BPM,” “Loop Base Note,” and “Times.” Even in this case, the delay time
cannot exceed 10,800 msec.
Loading ...
Loading ...
Loading ...