Loading ...
Loading ...
Loading ...
1190| Effects for the Sounds
f Voice1:
Resonance
–100…+100 Sets the intensity of resonance when Control Mode =
Manual
High Damp [%] 0…100 Sets the damping amount of resonant sound in the high
range
Pan L6…L1, C, R1…
R6
Sets the Voice1 stereo image
g Voice2: Pitch C0…B8 Sets the voice 2 Pitch for resonance
Fine [cents] –50…+50 Fine-adjusts the voice 2 pitch for resonance
Level 0…100 Sets the Voice2 output level
h Voice2:
Resonance
–100…+100 Sets the intensity of resonance when Control Mode =
Manual
High Damp [%] 0…100 Sets the damping amount of resonant sound in the high
range
Pan L6…L1, C, R1…
R6
Sets the Voice2 stereo image
i Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation Sources) at
the beginning of this part
Amt –100…+100 Amount of modulation source
▪ a: Control Mode
▪ f: Voice 1: Resonance
▪ h: Voice 2: Resonance
This parameter determines the resonance intensity.
When “Control Mode” = Manual, the “Resonance” parameter sets the intensity of
resonance. If the “Resonance” parameter has a negative value, harmonics will be
changed, and resonance will occur at a pitch one octave lower.
When “Control Mode” = LFO, the intensity of resonance varies according to the
LFO. The LFO sways between positive and negative values, causing resonance to
occur between specied pitches an octave apart in turn.
When “Control Mode” = D-mod, the resonance is controlled by the dynamic modu-
lation source. If JS X or Ribbon is assigned as the modulation source, the pitch
an octave higher and lower can be controlled, similar to when LFO is selected for
Control Mode.
Loading ...
Loading ...
Loading ...