Loading ...
Loading ...
Loading ...
Instrument setup
R&S
®
MXO 4 Series
87User Manual 1335.5337.02 ─ 05
Saveset to be loaded on preset
Select the saveset file that contains the required settings. If "Enable user-defined pre-
set" is enabled, this saveset is loaded when you press the [Preset] key.
"Preset file
name"
Enter the filename of the preset file. This file is loaded on user-
defined preset. The filename is also used when you save a preset file
with "Preset file name".
"File exten-
sion"
The file extension is .set.
<Directory>
Shows the currently used directory. To change the directory, tap the
button and select the correct directory in the file dialog.
Save as, Save
"Save as" opens the file selection dialog, where you can select the directory and enter
the filename of the preset file. "Save" saves the current settings immediately to the file
that is named in "Preset file name" in the current directory.
5.6.2 Factory preset
Access: "Menu" > "Settings" > "Preset" > "Factory".
Factory preset
Resets the instrument to the factory default settings, to the initial state. Factory settings
comprise all instrument settings, including display, intensity and transparency settings.
After loading factory defaults, perform a self-alignment to synchronize the signal data,
see Chapter 5.7.2, "Alignment", on page 89.
5.6.3 Secure erase
Access: "Menu" > "Settings" > "Preset" > "Secure erase"
To purge all non-volatile memory, a special delete function is available. This function
erases all user data, including instrument setups and reference waveforms. Calibration
data is retained on the instrument. The instrument reboots after erasing the data.
The procedure is required if user data must not leave the test area with the instrument,
e.g. when working in highly secured environments.
Preset setup
Loading ...
Loading ...
Loading ...