Loading ...
Loading ...
Loading ...
Measurements
R&S
®
MXO 4 Series
220User Manual 1335.5337.02 ─ 05
Trigger
source
Measurement
source
Trigger
level
Reference
level
Slope
Trigger
event
Delay to trigger
To configure the trigger conditions, use the trigger setup.
"Edges slope"
Sets the edge direction to be used for delay measurement: positive,
negative, or either edge.
Remote command:
MEASurement<mg>:AMPTime:DTOTrigger<n>:SLOPe on page 533
9.2.6 Statistics
Access: "Menu" > "Measurement" > "Statistics" tab.
In addition to the current measurement results, you can enable a statistical evaluation.
It returns the current, minimum and maximum measurement values, the average and
standard deviation, and the number of measured waveforms. The results are shown in
a separate tab below the grid. If the cursor measurement is active simultaneously, its
results are shown beside the statistics results.
Automatic measurements
Loading ...
Loading ...
Loading ...