Loading ...
Loading ...
Loading ...
Getting Started
R&S
®
MXO 4 Series
35User Manual 1335.5337.02 ─ 05
See also: "Menu" > "Horizontal" > "Setup" tab > "Ref Clock"
LAN
8-pin connector RJ-45 used to connect the instrument to a Local Area Network (LAN).
It supports up to 1 Gbit/s.
HDMI
HDMI Version 2.0 connector for an external monitor or projector. The monitor shows
the complete content of the instrument's screen.
USB B
USB 3.1 gen1 interface of type B (device USB), to be used for remote control of the
instrument.
USB
Two USB 3.1 gen1 interfaces of type A.
AC power supply connector and main power switch
The instrument supports a wide range power supply. It automatically adjusts to the cor-
rect range for the applied voltage. There is no line voltage selector.
The AC main power switch disconnects the instrument from the AC power line.
When you power up the instrument, be sure to comply with the warm-up phase speci-
fied in the data sheet before you start measurements.
3.2.4 Keys and controls
For an overview of the front panel keys, see Figure 3-1.
3.2.4.1 Power key
The [Power] key is located on the lower left corner of the front panel. It starts up and
shuts down the instrument's software.
The light of the key shows the instrument state, see Chapter 3.1.7, "Switching on or
off", on page 28.
3.2.4.2 Trigger controls
The keys and knob in the Trigger functional block adjust the trigger and start or stop
acquisition.
Instrument tour
Loading ...
Loading ...
Loading ...