Loading ...
Loading ...
Loading ...
Remote control commands
R&S
®
MXO 4 Series
531User Manual 1335.5337.02 ─ 05
*RST: BOTH
Usage: Asynchronous command
Manual operation: See "Envelope" on page 216
17.12.2 Measurement-specific settings
MEASurement<mg>:AMPTime:CSLope........................................................................... 531
MEASurement<mg>:AMPTime:ESLope........................................................................... 531
MEASurement<mg>:AMPTime:PTCount.......................................................................... 532
MEASurement<mg>:AMPTime:PSLope........................................................................... 532
MEASurement<mg>:AMPTime:DELay<n>:DIRection.........................................................532
MEASurement<mg>:AMPTime:DTOTrigger<n>:SLOPe..................................................... 533
MEASurement<mg>:AMPTime:DELay<n>:SLOPe............................................................ 533
MEASurement<mg>:AMPTime:CSLope <SetHoldClkSlp>
Sets the edge of the clock from which the setup and hold times are measured.
Suffix:
<mg>
.
1...16, index of the measurement
Parameters:
<SetHoldClkSlp> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
Manual operation: See "Clock slope" on page 218
MEASurement<mg>:AMPTime:ESLope <EdgesSlope>
Sets the edge direction to be counted: rising edges, falling edges, or both. The setting
is only relevant for edge count measurement MEASurement<mg>:MAIN is set to
EDGecount.
Suffix:
<mg>
.
1...16, index of the measurement
Parameters:
<EdgesSlope> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
Manual operation: See "Edges slope" on page 217
Automatic measurements
Loading ...
Loading ...
Loading ...