Loading ...
Loading ...
Loading ...
Trigger
R&S
®
MXO 4 Series
153User Manual 1335.5337.02 ─ 05
Remote command:
TRIGger:EVENt<ev>:LEVel<n>:SLEW:LOWer on page 474
Range
Selects how the time limit for the slew rate is defined. The time measurement starts
when the signal crosses the first trigger level - the upper or lower limit depending on
the selected slope. The measurement stops when the signal crosses the second level.
"Within"
Triggers on slew rates inside a given time range. The range is defined
by "Slew rate" and "±Delta".
"Outside"
Triggers on slew rates outside a given time range. The range defini-
tion is the same as for "Within" range.
"Shorter"
Triggers on slew rates shorter than the given "Slew rate" limit.
"Longer"
Triggers on slew rates longer than the given "Slew rate" limit.
Remote command:
TRIGger:EVENt<ev>:SLEW:RANGe on page 475
Slew rate
For the ranges "Within" and "Outside", the slew rate defines the center of a range
which is defined by the limits "±Delta".
For the ranges "Shorter" and "Longer", the slew rate defines the maximum and mini-
mum slew rate limits, respectively.
Remote command:
TRIGger:EVENt<ev>:SLEW:RATE on page 476
±Delta
Defines a time range around the given slew rate.
Remote command:
TRIGger:EVENt<ev>:SLEW:DELTa on page 475
7.4.10 Setup & Hold
Access: "Menu" > "Trigger" > "Setup" tab > "Type = Setup & Hold"
The setup & hold trigger analyzes the relative timing between two signals: a data signal
and the synchronous clock signal. Many systems require, that the data signal must be
steady for some time before and after the clock edge, for example, the data transmis-
sion on parallel interfaces. With this trigger type, you can also test the time correlation
of sideband and in-band signals.
The setup & hold trigger is also known as Data2Clock trigger.
Trigger types
Loading ...
Loading ...
Loading ...