Loading ...
Loading ...
Loading ...
Waveform generator (option R&S MXO4-B6)
R&S
®
MXO 4 Series
367User Manual 1335.5337.02 ─ 05
FSK rate
Sets the frequency at which signal switches between "Frequency 1" and "Frequency
2".
Remote command:
WGENerator<wg>:MODulation:FSK[:RATE] on page 711
15.1.3 Sweep settings
Sweep is available only for sine waveforms.
Access: "Gen" signal activator > "Gen1" or "Gen2" > "Setup" tab > "Function type" =
"Sine" > "Sweep".
In the sweep mode, the R&S MXO 4 generates a signal whose frequency gradually
changes from the "Start frequency" to the "Stop frequency" for a certain "Sweep time".
For a step-by-step description of the sweep setup, see Chapter 15.3.3, "Configuring a
sine sweep waveform", on page 375.
Sweep state
Enables or disables the sweeping.
Remote command:
WGENerator<wg>:SWEep[:STATe] on page 716
Sweep type
Sets the type of the sweep, a linear or logarithmic change of the frequency.
Remote command:
WGENerator<wg>:SWEep:TYPE on page 717
Setup of the waveform generator
Loading ...
Loading ...
Loading ...