Loading ...
Loading ...
Loading ...
Protocol analysis
R&S
®
MXO 4 Series
319User Manual 1335.5337.02 ─ 05
Type
Selects the CAN-High or CAN-Low line. CAN uses both lines for differential signal
transmission.
If you measure with a differential probe, connect the probe to both CAN-H and CAN-L
lines, and select the data "Type" = CAN-H.
If you use a single-ended probe, connect the probe to either CAN_L or CAN_H, and
select the data type accordingly.
Remote command:
SBUS<sb>:CAN:TYPE on page 642
Transceiver mode
Selects the transceiver mode for the CAN decoding.
"SIC mode"
Signal improvement capability (SIC) mode. The possible bit rate is up
to 8 Mbit.
"FAST mode"
Fast mode. The possible bit rate is up to 20 Mbit.
Remote command:
SBUS<sb>:CAN:TRCVmode on page 646
Nominal bit rate
Sets the number of transmitted bits per second.
Remote command:
SBUS<sb>:CAN:BITRate on page 642
Sample point
Sets the position of the sample point within the bit in percent of the nominal bit time.
Remote command:
SBUS<sb>:CAN:SAMPlepoint on page 643
FD bit rate
Sets the number of transmitted bits per second for the CAN-FD frame.
Remote command:
SBUS<sb>:CAN:FDATa:DBITrate on page 644
FD sample point
Sets the position of the sample point within the bit in percent of the nominal bit time for
the CAN-FD frame.
Remote command:
SBUS<sb>:CAN:FDATa:SAMPlepoint on page 644
XL bit rate
Sets the number of transmitted bits per second for the CAN XL frame.
Remote command:
SBUS<sb>:CAN:XDATa:DBITrate on page 645
CAN (option R&S
MXO4-K520)
Loading ...
Loading ...
Loading ...