Loading ...
Loading ...
Loading ...
Measurements
R&S
®
MXO 4 Series
216User Manual 1335.5337.02 ─ 05
Envelope
This setting is only available for measurements on envelope waveforms, see Acquisi-
tion mode.
"Both"
The upper and the lower envelope are used in measurements. For
time measurements, the averages of min and max values are used,
that is, the measurement is performed on the average waveform built
from the upper and lower envelope.
"Maximum"
Measurements are performed on the upper envelope.
"Minimum"
Measurements are performed on the lower envelope.
Remote command:
MEASurement<mg>:ENVSelect on page 530
9.2.5.2 Measurement type specific settings
You can define additional parameters for some measurements.
Specific type
Selects the type of measurement that you want to define the settings for.
Source
Sets the source of the measurement.
Remote command:
MEASurement<mg>:SOURce on page 529
Reference levels
Selects the set of reference levels that is used for the measurement. Define the refer-
ence level set before you select it, see Chapter 9.2.3, "Reference level", on page 209.
Gate
Selects the gate that is used for limiting the measurement range. Define a gate before
you select it, see Chapter 9.2.2, "Gate settings for measurements", on page 207.
Label
Adds a user-defined label to the measurement.
Pulse count
Available, if "Specific type" is set to "Pulse train".
Sets the number N of positive pulses for the "Pulse train" measurement. This measure-
ment measures the duration of N positive pulses from the rising edge of the first pulse
to the falling edge of the N-th pulse.
Remote command:
MEASurement<mg>:AMPTime:PTCount on page 532
Pulse slope
Available, if "Specific type" is set to "Pulse count".
Sets the first slope of the pulses to be counted.
Automatic measurements
Loading ...
Loading ...
Loading ...