Loading ...
Loading ...
Loading ...
Applications
R&S
®
MXO 4 Series
245User Manual 1335.5337.02 ─ 05
Remote command:
FRANalysis:FREQuency:STARt on page 574
FRANalysis:FREQuency:STOP on page 574
Points
Selects, if the number of points are measured as total or per decade and sets the num-
ber of points.
Remote command:
FRANalysis:POINts:TOTal on page 578
FRANalysis:POINts:MODE on page 577
FRANalysis:POINts:LOGarithmic on page 577
Amplitude
Sets a fixed amplitude for the frequency response analysis.
Remote command:
FRANalysis:GENerator:AMPLitude on page 575
User load
Selects the generator voltage display for 50Ω or high impedance load.
Remote command:
FRANalysis:GENerator:LOAD on page 575
Amplitude mode
Selects, if the amplitude is a constant value ("Amplitude") or is defined as an amplitude
profile.
Remote command:
FRANalysis:POINts:MODE on page 577
Amplitude profile
Opens a dialog to set the amplitude profile. See Chapter 11.1.3.2, "Amplitude profile",
on page 246.
You can then define different amplitudes for different frequencies. The amplitude profile
is useful when testing sensitive circuits, where the amplitude gets too high. In this case
distortion might occur.
If this function is enabled, a green colored diagram of the amplitudes for the different
frequencies can be displayed on the screen.
Remote command:
FRANalysis:AMPLitude:MODE on page 574
FRANalysis:AMPLitude:ENABle on page 583
Run
Starts the frequency response analysis.
Remote command:
FRANalysis:STATe on page 573
Repeat
Repeats the measurement, using the same parameters.
Frequency response analysis (option R&S
MXO4-K36)
Loading ...
Loading ...
Loading ...