Loading ...
Loading ...
Loading ...
Waveform analysis
R&S
®
MXO 4 Series
178User Manual 1335.5337.02 ─ 05
Scale mode
By default, the vertical scale is adapted to the current measurement results automati-
cally to provide an optimal display. However, if necessary, you can define scaling val-
ues manually to suit your requirements.
"Manual"
Enter the required values for "Vertical scale" and "Vertical offset".
"Auto"
"Vertical scale" and "Vertical offset" are read-only.
Remote command:
CALCulate:MATH<m>:VERTical:SCALe:MODE on page 501
Vertical scale
Sets the scale of the y-axis in the math function diagram. The value is defined as
"<unit> per division", e.g. 50
mV/div. In this case, the horizontal grid lines are displayed
in intervals of 50 mV.
If Scale mode is set to "Auto", this setting is read-only.
Remote command:
CALCulate:MATH<m>:VERTical:SCALe[:VALue] on page 500
Vertical offset
Sets a voltage offset to adjust the vertical position of the math function on the screen.
Negative values move the waveform up, positive values move it down.
If Scale mode is set to "Auto", this setting is read-only.
Remote command:
CALCulate:MATH<m>:VERTical:OFFSet on page 500
Unit
Sets a user-defined unit for the math operation.
8.3 History
The history accesses the data of previous acquisitions and provides them for further
analysis.
8.3.1 About history
If a continuous acquisition runs, the captured data is stored in the sample memory and
the current acquisition is processed and shown on the display. After the acquisition is
stopped, the history accesses the captured samples that were stored, displays these
samples as history waveforms, and makes them available for further analysis. It con-
siders all channels that were enabled during the running acquisition. When a new
acquisition is started with [Run / Stop] or [Single], the memory is cleared and written
anew.
History
Loading ...
Loading ...
Loading ...