Loading ...
Loading ...
Loading ...
Measurements
R&S
®
MXO 4 Series
198User Manual 1335.5337.02 ─ 05
"VLine & Rhombus"
Vertical line and rhombus: the cursors are displayed as vertical lines.
The intersections of the cursors with the waveforms are displayed by
rhombus-shaped points.
"Rhombus"
The intersections of the cursors with the waveforms are displayed by
rhombus-shaped points.
Remote command:
CURSor<cu>:STYLe on page 557
Type
Defines the cursor type to be used for the measurement.
"X" (vertical cursors )
Both vertical cursor lines are set automatically to the trigger position,
and you can reposition them manually.
"Y" (horizontal cursors)
Horizontal cursors are positioned automatically along the waveform
and can be adjusted manually.
"X&Y" (both vertical and horizontal cursors)
Horizontal cursors are positioned automatically along the waveform
and vertical cursors are set to the trigger position. You can reposition
all cursor lines manually.
Remote command:
CURSor<cu>:FUNCtion on page 549
Second source, Source 2
Enables and selects a second source for the cursor measurements. If enabled, the
second cursor lines Cu2 measure on the second source. Using a second source, you
can measure differences between two channels with cursors.
Remote command:
CURSor<cu>:USSource on page 550
CURSor<cu>:SSOurce on page 550
Source
Defines the source of the cursor measurement. Any of the input signal, math or refer-
ence waveforms can be selected.
Remote command:
CURSor<cu>:SOURce on page 549
Envelope, Envelope 2
Define which horizontal cursor is positioned to the maximum and which to the minimum
envelope values.
Envelope selection is effective under the following conditions:
●
The acquisition mode of the cursor source waveform is set to envelope, see Acqui-
sition mode.
●
Track waveform is enabled.
●
Both horizontal and vertical cursors are enabled (Type = "X&Y").
Cursor measurements
Loading ...
Loading ...
Loading ...