Loading ...
Loading ...
Loading ...
Effect parameters |723
a: OSC Mode
b: Note Interval
b: Note Fine
The “OSC Mode” parameter selects the oscillator operation mode. When
Note (Key Follow) is selected, the oscillator’s frequency is determined based
on the note number, allowing you to use it as an octaver. The “Note Interval”
parameter sets the pitch offset from the original note number by semitone
steps. The “Note Fine” parameter allows you to fine-tune in steps of cents.
d: Envelope Pre LPF
This parameter sets the upper limit of the frequency range to which very low
harmonics are added. Adjust this parameter if you do not want to add lower
harmonics to the higher range.
Grain Shifter
This effect cuts extremely short samples (‘grains’) from the input signal
waveform and plays them repeatedly, giving a mechanical character to the
sound.
+
Left
Right
Sample Cycle
FX Amt
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
LFO
D
-mod
Trigger
Grain Shifter
a Duration 0…100 Sets the duration of the grain
Src Off…Tempo Selects the source that will modulate the duration of
the grain
Amt –100…+100 Sets the amount by which the grain duration will be
modulated
b LFO Sync Src Off…Tempo Selects the modulation source that will reset the LFO
Loading ...
Loading ...
Loading ...