Loading ...
Loading ...
Loading ...
Effect parameters |585
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation
Sources) at the beginning of this part
Amt –100…+100 Amount of modulation source
a: Loop Time [msec]
With Auto, the loop time is automatically set. Otherwise, you can specify the
loop time.
When Auto is selected, the Loop Time is automatically set to the time it takes
for a performance recorded while the Modulation Source or “Manual REC
Control” is on. However, if the time length exceeds 10,800msec, the loop
time will be automatically set to 10,800msec.
c: Time Over?
You can set the delay time up to 10,800msec. If the delay time exceeds this
limit, the error message “OVER!” appears in the display. Set the delay time
parameters so that this message will not appear. “Time Over?” is only a
display parameter.
b: Loop BPM Sync
c: BPM
d: Loop Base Note
d: Times
If “Loop BPM Sync” is on, the “Times” setting is ignored; the loop time is
determined by “BPM,” “Loop Base Note,” and “Times.” Even in this case, the
delay time cannot exceed 10,800 msec.
“Hold” procedure (when Loop Time = Auto)
1 Select the following options for each parameter:
“Loop Time [msec]” = Auto
“REC Control Src” = JS +Y: #01
“RST Control Src” = JS –Y: #02
“Manual REC Control” = REC Off
“Manual RST Control” = RESET
“Loop BPM Sync” = Off
It should be noted that all recordings will be deleted while Reset is On.
Loading ...
Loading ...
Loading ...