Loading ...
Loading ...
Loading ...
Effect parameters |557
g [G]Input Reverb Mix 0…100 Sets the balance between the dry and reverb
sounds of the gate control signal
Threshold 0…100 Sets the gate threshold level
h [G]Polarity +, – Switches between non-invert and invert of the
gate on/off state
i [G]Attack 1…100 Sets the attack time
Release 1…100 Sets the release time
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation
Sources) at the beginning of this part
Amt –100…+100 Amount of modulation source
f: [G]Envelope Select
f: Src
g: [G]Input Reverb Mix
g: Threshold
The “[G]Envelope Select” parameter enables you to select whether turning
the gate on and off is triggered by the input signal level or controlled directly
by the modulation source. You can select from Off to Tempo for the Src pa-
rameter to specify the modulation source.
When “[G]Envelope Select” is set to Input, the gate is controlled by the level
of signals that are the combination of the dry sound and the reverb sound.
When the signal level exceeds the threshold, the gate opens and the reverb
sound is output.
Normally, set “[G]Input Reverb Mix” to Dry (the gate is controlled only by the
dry sound). If you wish to extend the gate time, set the “[G]Input Reverb Mix”
value higher and adjust the “Threshold” value.
Loading ...
Loading ...
Loading ...