Loading ...
Loading ...
Loading ...
392| Customizing and editing the Sounds
Setting octave and fine tuning
▪ Use the Oct(ave) parameter to adjust the pitch of the selected oscillator in
octave units (-2…+1). The normal octave is 0 (Zero).
▪ Use the Transpose parameter to adjust the pitch of the selected oscillator
over a range of ±1 octave (-12…+12 semitones).
▪ Use the Tune parameter to adjust the pitch of the sample over a range of ±1
octave (-1200…+1200 cents of a semitone) .
Setting the velocity switch between the Low and High layers
▪ Use the Vel SW L–>H parameter to set the velocity value dividing the High
and Low multisamples for the selected oscillator. Notes struck at this value
or harder will be played by the High multisample.
Choosing an AMS (Alternate Modulation Source)
When the AMS option is assigned to the Offset parameter, the Offset
Intensity by AMS and AMS parameters become available. A list of AMS
sources can be found in the Appendix.
When the
Offset Intensity by AMS parameter has a positive value, the se-
lected Offset point will depend by the AMS value. For example, with the
Velocity AMS, playing softly will select the Off or 1st Offset, while playing
loudly will select the 6th or No Attack Offset.
When the
Offset Intensity by AMS parameter has a negative value, the se-
lection will happen in reverse (higher-numbered Offsets will be selected be-
fore the lowest-numbered ones).
Loading ...
Loading ...
Loading ...