Loading ...
Loading ...
Loading ...
586| Effects for the Sounds, Voice, Guitar
2 Set “Manual RST Control” = Off
Reset is cancelled and the unit enters Rec ready mode.
3 Push the joystick in the +Y direction (forward) and play a phrase you wish to
hold. When you pull the joystick to its original position, the recording will be
finished and the phrase you just played will be held.
Loop Time is automatically set only for the first recording after resetting.
If the time length exceeds 10,800msec, Loop Time will be automatically
set to 10,800msec. (If you have set “Times” to 1–10,800msec, the specified
loop time will be used regardless of the time taken from pushing the joystick
forward until it is pulled back. However, the recording method remains the
same. The phrase being played while the joystick is pushed forward will be
held.)
4 If you made a mistake during recording, pull the joystick in the –Y direction
(back) to reset. In this way, the recording will be erased. Repeat step 4. again.
5 The recorded phrase will be repeated again and again. You can use this to
create an accompaniment.
6 By pushing the joystick in the +Y direction (forward), you can also overdub
performances over the phrase that is being held.
e: REC Control Src
g: Manual REC Control
“REC Control Src” selects the modulation source that controls recording.
If this modulation is on, or if “Manual REC Control” is set to On, you can re-
cord the input signal. If a recording has already been carried out, additional
signals will be overdubbed.
The effect is off when a value for the modulation source specified for
the “REC Control Src” parameter is 63 or smaller, and the effect is on when
the value is 64 or higher.
f: RST Control Src
h: Manual RST Control
The “RST Control Src” parameter specifies the modulation source that con-
trols the reset operation.
When you set this modulation source to On, or “Manual RST Control” to RE-
SET, you can erase what you recorded. If the Loop Time parameter has been
set to Auto, the loop time is also reset.
The effect is off when a value for the modulation source specified for
the “RST Control Src” parameter is 63 or smaller, and the effect is on when
the value is 64 or higher.
Loading ...
Loading ...
Loading ...