Loading ...
Loading ...
Loading ...
Effect parameters |675
h Mid2 Cutoff [Hz] 500…20.00k Sets the center frequency for Mid/High EQ 2
(peaking type)
Q 0.5…10.0 Sets the band width of Mid/High EQ 2
Gain [dB] –18…+18 Sets the gain of Mid/High EQ 2
i Direct Mix 0…50 Sets the amount of the dry sound mixed to the
distortion
Speaker Simulation Off, On Switches the speaker simulation on/off
j Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See the list of DMS (Dynamic Modulation
Sources) at the beginning of this part
Amt –100…+100 Amount of modulation source
a: Wah
The Wah parameter switches the wah effect on/off.
a: Sw
This parameter sets how the wah effect is switched on and off via the modu-
lation source.
When “Sw” = Moment, the wah effect is usually turned off. It is turned on
only when you press the pedal or operate the joystick.
When a value for the modulation source is less than 64, “off” speed is
selected, and when the value is 64 or higher, “on” is selected.
When “Sw” = Toggle, the wah effect is switched between on and off each
time you press the pedal or operate the joystick.
The switch will be turned on/off each time the value of the modulation
source exceeds 64.
b: Wah Sweep Range
b: Wah Sweep Src
This parameter sets the sweep range of the wah center frequency. A nega-
tive value will reverse the direction of sweep. The wah center frequency can
be controlled by the modulation source specified in the “Wah Sweep Src”
parameter.
Loading ...
Loading ...
Loading ...